|
Excavator Models
The rugged frame of the CX372 heavy-duty brush mower, featuring an 82" path width, is designed to stand up and perform in rough terrain. The hungry 72" mouth of this unit is protected by a heavy-duty chain that controls flying debris, but still allows brush to easily enter. The rear of the unit is also guarded by a chain curtain so standing brush enters and mulched debris exits.
|
|
Features
|
Two Cuts per Pass
As the rotating rotor mass throws the slasher blades at small diameter trees, the blade slices small sections away as the Brush Cutt advances forward. The curved cutting tips of the slasher blades give the Brush Cutt two cuts per pass of each blade. The leading tip takes a small bite and is immediately followed by the second tip taking another bite at 26–52 slashes per second with devastating results. Available in either 2 or 4 blade configurations the Brush Cutt’s reversible/replaceable blades are made of long lasting 1/4" AR 400 steel.
|
Gear Box
Standard on all Brush Cutt models is a relief valve. Set at 3,000 psi, this valve disengages the driveline if the hydraulic system pressure is too great, thereby protecting both the skidsteer and the Brush Cutt.
The Brush Cutt uses a bevel gearbox capable of handling up to 90HP for final drive output. More durable than conventional direct drive setups these gearboxes prevent shocks from cutting being passed to the drive motor.
|
Slasher Blades
Crafted from 1/4" AR 400 steel, the unique profile of the slasher blades provides increased cutting surface. The blades thin reversible profile continuously provides a sharp edge.
|
Blade Mount
To secure slasher blades to the blade assembly, Baumalight uses Gr. 8 bolts capped off with castle nuts and cotter pins. The blade mount uses a fully welded collar to drop the blade—this spacing helps to reduce the blade from binding while in operation.
|
3-Way Model
Designed for easy service, the 3-Way models feature a heavy-duty rotor with 3 fixed extensions. Each extension is finished off with a slasher blade. This configuration is capable of providing up to 39 slashes per second.
|
Rotor
Using a 3/4" top plate and a 3/8" bottom plate this heavy-duty rotor sandwiches the three–way blade assembly in place.
|
Shield
To protect the output shaft from impact or contamination caused by debris, each model of Brush Cutt is finished off with a heavy duty output shaft shield.
|
|
Available on Pack Wing PTO Power Packs
All Excavator Brush Cutt models are available with Baumalight’s Pack Wing PTO power packs for more carrier versatility.
|
