More Opportunities

New standard capabilities give your operation new harvesting opportunities.

Optimized Stalk Rolls

Stalk rolls have point-to-point contact for improved feeding and greater performance. Additionally, the point-to-point design of the rolls ensures the stalk is pulled through without the side-to-side vibration associated with an interlocking roll design. This smoother operation leads to reduced header loss levels. Stalk rolls have point-to-point contact for better feeding and greater performance.

20 Inch Auger

The large 20 inch diameter auger reaches over the gatherer and row unit for maximum capacity and efficient feeding in any condition.

Chopping or Non-Chopping

Available in chopping or non-chopping models, the header allows you to operate in almost any field regardless of residue management preferences. The chopping heads allow the operator to engage or disengage chopping capabilities at each row unit with an easy to use lever.

Fore-Aft Header Tilt

Heads are equipped with hydraulic header fore-aft pitch capability, adjustable on the go from the cab. This allows the operator to “match” the header-feeding angle to the combine height for optimized feeding and exceptional downed corn performance. A hydraulic accumulator provides protection for the combine and header when running the header on the ground.

Improved Results, Reduced Loss

High performance features will improve results during harvest and our smart design reduces header loss ultimately leading to an increase in profits.

Low Density Polyethylene Construction

The low-density polyethylene construction of our snouts and gatherers absorbs shock from ears reducing the number of bouncing ears and amount of butt shelling meaning the corn harvested makes it into the combine rather than getting left behind as header loss. Each snout is equipped with reflective markers to improve visibility to the snouts in low light situations.

Center Auger Hood

The standard center auger hood prevents cobs from going over the top of the header opening while the canted shape of deck plate openings reduces impact shelling from cob impact.

Auger Flighting

Auger flighting pitch has increased while the auger speed has decreased. This allows the auger to gently convey more crop leading to reduced header loss while retaining maximum capacity.

Lugs and Gathering Chains

Design and length of lugs on gathering chains strip less leaves and reduce the amount of trash that is pulled into the machine, which means the combine processes less, increasing operating efficiency.

Snout design

A cove shaped snout design gets under ears without knocking them loose and prevents the ramp launching of cobs. The snout shape is also optimized to slide under and gently pick up downed corn, allowing the header to perform well in a wide range of harvesting conditions.